Re: Which Coil do you guys use?
Posted by Mike On 2011/4/22 1:31:37
It's wider now than the .014. Below is an excerpt from the Packard tune up guide that i used to set the points in that range. I'll double check them again tomorrow.
I have no way of checking the timing but by ear...advancing until it pings under load and then backing it off a tad bit. Any timing marks on the dist have long since been wore off or are gone.
Attach file:
(114.76 KB)
I have no way of checking the timing but by ear...advancing until it pings under load and then backing it off a tad bit. Any timing marks on the dist have long since been wore off or are gone.
Attach file:
(114.76 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=75328