Re: Getting at instrument wiring???

Posted by JimGnitecki On 2008/7/4 16:14:04

HH56: Thank-you for pointing me in the right general direction.

Question: Once the nuts have been successfully found and removed by someone with very dextrous fingers, is it a mortal sin to simply not re-install them so that future access will require removing only the easy TOP screws? Or, will this lead to vibration and movement of the instrument panel?

I'm asking because if the nuts are at the bottom of studs that extend DOWN from the panel, then the studs withOUT nuts should still locate the panel's bottom edge, and the TOP screws might be sufficient to prevent vibration?

Jim G