Re: How to troubleshoot my overdrive?
Posted by Jay Faubion On 2008/7/4 21:50:28
(Just got back from the fireworks show)
I picked at the coil with a knife tip before we left for the park, and sure enough the annealed wire came loose where the break was. I pulled about a half inch of it away from the coil and checked it with the ohm meter. Good as gold!
I'm going to try and c-a-r-e-f-u-l-l-y solder it up tomorrow and hope for the best.
49Packard, I hope I can say I will have had the same experience as you!
Thanks, and I'll post tomorrow with the results.
I picked at the coil with a knife tip before we left for the park, and sure enough the annealed wire came loose where the break was. I pulled about a half inch of it away from the coil and checked it with the ohm meter. Good as gold!
I'm going to try and c-a-r-e-f-u-l-l-y solder it up tomorrow and hope for the best.
49Packard, I hope I can say I will have had the same experience as you!
Thanks, and I'll post tomorrow with the results.
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=9016