Re: maximum wear for 356 valve stems?

Posted by Bobs51 On 2011/12/11 16:48:52
Quote:
Mite even need to check the valves to be sure if they are valves made for a Packard engine. Stem diamter of valve???



The valves were correct. Still had the valves with the Packard name on the under-side. Owen is correct, I need to confirm the measurement from the top of the guide to the top of the block so I can drive the new guides in to the proper depth.

Thanks for all the info guys.

This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=91134