Re: R9 OD fuse question
Posted by HH56 On 2012/8/8 10:48:12
It's a 30 amp fuse but not shown on this schematic. It is shown on the 48 R9 schematics. It's also a good idea to see if you can find the pieces to add the reverse safety switch per Service Counselor Vol21 #15 if yours doesn't have it.
There are two wires to the bulb and it should be in an isolated or independent socket. One wire from terminal 4 of OD relay for power when OD is on and prepped and the other wire to terminal 7 of solenoid for the contact that opens the ground side and cuts the light when it actually goes into OD. If there is not a provision for two leads, perhaps someone substituted an ordinary dash illumination lamp socket.
Attach file:
(46.79 KB)
There are two wires to the bulb and it should be in an isolated or independent socket. One wire from terminal 4 of OD relay for power when OD is on and prepped and the other wire to terminal 7 of solenoid for the contact that opens the ground side and cuts the light when it actually goes into OD. If there is not a provision for two leads, perhaps someone substituted an ordinary dash illumination lamp socket.
Attach file:
(46.79 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=107239