Re: position of R9 Lockout Control Lever on OD case ?

Posted by HH56 On 2012/10/23 19:18:46

Good news the solenoid is working.

The other contacts are very low current so probably in good shape. The pull in coil disconnect is the one that gets the heavy use as you noticed with the sparking. It would be a good idea just to see it's condition and decide if it's pitted enough you want to start looking for a replacement contact kit.

Remove the 4 terminal screws completely and then the two nuts on end. Cover will slide off. The light and ground out contacts are at the end of plunger and the pull in contact is just behind the coil toward the middle.