Re: position of R9 Lockout Control Lever on OD case ?
Posted by HH56 On 2012/11/6 13:24:38
The trunk connectors should be behind the Left tail light area. Should look similar to these only with wires in MUCH better condition. In a 48 22nd series the large 4 wire square ones should be the tail and the stop lights. Small 2 wire are for turnsignals. 23rd series will be slightly different. There are similar looking connectors under the dash at the extreme left side.
The wires do plug in. There is a pin on one side of the internal connection which fits in a hole in the wire tab that's used as a locking arrangement. In normal circumstances the wire should be very difficult to pull out but if the pin has worn or the connector damaged, the locking may not function well.
Switches are the same for 22-23 series but maybe arranged differently. I don't remember the layout. Headlight switch has the same terminals and breaker as the one shown but difference is it's more square instead of rectangular.
Attach file:
(40.41 KB)
The wires do plug in. There is a pin on one side of the internal connection which fits in a hole in the wire tab that's used as a locking arrangement. In normal circumstances the wire should be very difficult to pull out but if the pin has worn or the connector damaged, the locking may not function well.
Switches are the same for 22-23 series but maybe arranged differently. I don't remember the layout. Headlight switch has the same terminals and breaker as the one shown but difference is it's more square instead of rectangular.
Attach file:
(40.41 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=112569