Re: 1948 Deluxe rear window

Posted by HH56 On 2013/5/13 18:55:50

The window would stay in the top position and blocked so it can't fall.

Based on the instructions in manual crank the regulator to make sure it is in the normal window down position. If it is up, without the weight of the window you might need to clamp the gear sector portion in a vise and push down on the arm against the spring while cranking to lower the arm. Once in that down configuration the assembly would be inserted in the access hole and worked up into a general position where the cross or free arm pin can slide in the channel in door. Once that pin is inserted then move the regulator into position so the screws can be installed. If you can get one started then if needed you can crank or twist the regulator using the one screw as a pivot until the rest line up. Once the screws are installed remove the block and lower the window to the bottom and insert the arm pins in window channel. Then install the retaining clips and raise or lower the window a little to make the adjustments for the down stop.