Moulding Clips
Posted by BigKev On 2013/5/23 12:03:07
Attached below is the 3 styles of moulding clips used from the belt line trim on my '54 Clipper. The most used clip is the spring wire push-in clip.
I need to find a place that sells them by the box (25 or 50) as opposed to per piece which gets expensive really quick. So I am looking for a source or part number for a push in wire moulding clip that measures 1 1/8" tall (flat side to curved side). The width is 1 1/4" (flat to flat), but is not that important.
The screw on style ones are easier to locate by the box, but these wire ones are proving to be illusive.
The were used in the larger holes especially on the front fenders. Also used on the trim around the side windows.
Any leads or an Auveco number that could be used for reference is appreciated.
The larger clip is an odd ball, and was used to hold the junior wide style trim on back doors, and I may have enough original ones to be ok there.
Attach file:
(53.99 KB)
I need to find a place that sells them by the box (25 or 50) as opposed to per piece which gets expensive really quick. So I am looking for a source or part number for a push in wire moulding clip that measures 1 1/8" tall (flat side to curved side). The width is 1 1/4" (flat to flat), but is not that important.
The screw on style ones are easier to locate by the box, but these wire ones are proving to be illusive.
The were used in the larger holes especially on the front fenders. Also used on the trim around the side windows.
Any leads or an Auveco number that could be used for reference is appreciated.
The larger clip is an odd ball, and was used to hold the junior wide style trim on back doors, and I may have enough original ones to be ok there.
Attach file:
(53.99 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=123747