Re: 21st series bodies... weaknesses?

Posted by Mark Graber On 2013/12/7 19:23:41
Just this morning, I retrieved my 2106-2122 from the body shop to replace rockers and repair front splashers. My car started life in Pennsylvania, so spent a while with salt and sand.

The rockers are attached to the pan with several doglegs that are formed from U-shaped steel. The rockers drop down from the floor, about even with the bottom of the frame. The bottom and sides of the U must have really caught road junk to the point that they had rusted all the way through and also through the backside of the rocker. Also, found rust holes in the front and rear of the rockers.

The other problem areas are the front splashers and fenders just under the headlights. This area is hard to illustrate, but parts 379263 and 379262 are intended to drain water toward channels and a hole in the center of 378735. The top right of these splashers actually bends downward to drain to the center. In front of the wheel, you can reach up and forward at the top of the fender and check for rust on these parts. Mine had rusted through and had rusted a big hole at the bottom of the headlight bucket as well. Some really neglected Clippers actually have rust through the fenders right underneath the headlights.

I haven't worked my way back to the trunk yet, but Howard is right on, as usual. I recall seeing several Clippers with rusted trunks undoubtedly from a failed seal.

Good luck!

Attach file:



jpg  (130.96 KB)
4217_52a3bc0d591c1.jpg 982X1280 px

This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=136224