21st series Headlight bucket wiring

Posted by HH56 On 2014/1/16 17:10:24

On a Clipper, would someone please tell me or better yet post a photo where the rubber cord exits the engine compt and goes under the fender to headlight buckets. I don't see any obvious places in the inner fender panels and the car has been apart so long my memory has failed.

Both headlight cables connect at the terminal block on L fender, go forward a few inches & clamped and then what happens. I know one has to exit to left and other goes across front of radiator and then somehow gets into the fender. Not sure where that happens on either side. Am wondering if there is enough slack that I could shorten the cable on one side or the other or maybe both by 3-4 inches.

No one else seems to stock that rubber multiconductor and now RI Wiring is discontinuing it too. I bought the last of what they had. Worked out to a little over 9' or roughly 10" shorter than what I would have liked to have. Would hate to have to do it differently if I can fudge a few inches using the proper looking cable.