Re: vacuum antenna bezel diff between 47 and 48-50
Posted by HH56 On 2014/3/16 12:28:17
Here is what the 47 piece looks like with dimensions. Perhaps you can get Jerry to compare with the 48-50 item.
If the differences are relatively small, perhaps it would be possible to fine tune the fit with a file. After our emails yesterday, I did look thru some boxes and found a rubber pad was used on the bottom at the fender. It has a lip that extends over the grommet so a little mismatch to the fender would be covered as long as it was not severe. Steele does not list a pad for the 47 so I am going to have to try the one he has for 48-50.
As I see it, the one item that may be an issue is the inner diameter. The 47 is one inch ID and I believe you said the 48 was also. I am wondering how your 3/4" diameter antenna would fit in either without some kind of bushing and would the nut cover the top of the grommet or just the bushing.
Obviously can't speak for Jerry or know his process but one possibility on the inner dimension -- if the rest of the dimensions are close enough to his mold to be usable -- is a special made item. With my AC project, he was more than willing to accommodate my requests for two of his production knobs but with different size holes and a dash bezel that was plain instead of one with the molded in printing and also with a smaller cast in hole. Perhaps his process would enable a grommet with a smaller ID. Worth a call or email to check.
Attach file:
(23.87 KB)
(18.98 KB)
If the differences are relatively small, perhaps it would be possible to fine tune the fit with a file. After our emails yesterday, I did look thru some boxes and found a rubber pad was used on the bottom at the fender. It has a lip that extends over the grommet so a little mismatch to the fender would be covered as long as it was not severe. Steele does not list a pad for the 47 so I am going to have to try the one he has for 48-50.
As I see it, the one item that may be an issue is the inner diameter. The 47 is one inch ID and I believe you said the 48 was also. I am wondering how your 3/4" diameter antenna would fit in either without some kind of bushing and would the nut cover the top of the grommet or just the bushing.
Obviously can't speak for Jerry or know his process but one possibility on the inner dimension -- if the rest of the dimensions are close enough to his mold to be usable -- is a special made item. With my AC project, he was more than willing to accommodate my requests for two of his production knobs but with different size holes and a dash bezel that was plain instead of one with the molded in printing and also with a smaller cast in hole. Perhaps his process would enable a grommet with a smaller ID. Worth a call or email to check.
Attach file:
(23.87 KB)
(18.98 KB)This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=141066