Re: Help! Need some ideas!
Posted by Ozstatman On 2008/8/30 17:01:19
Quote:
Chuck,
Below is a picture of the puller I used, don't know if it's the same as yours but same principle. The big nut pushing on the centre of the axle should be continuously tightened and I mean tightened, really lean on it! A combination of tightenening and hammering WILL loosen it off.
Attach file:
(31.48 KB)
Boro wrote:
Subject: removing rear brake drums
52 300 sedan
Here's where I'm at and what I've tried. I have the exact puller that is supposed to be used for this job. Same as picture from this website.........
I have been now for the past 3 hours, hitting it to tighen it, then hitting the center shaft just about as hard as I can with a 4# hammer.
It sure the heck doesn't seem to be moving to me. Any help or suggestions appreciated. Drastic measures are starting to go through my mind!..............Chuck in AZ
Chuck,
Below is a picture of the puller I used, don't know if it's the same as yours but same principle. The big nut pushing on the centre of the axle should be continuously tightened and I mean tightened, really lean on it! A combination of tightenening and hammering WILL loosen it off.
Attach file:
(31.48 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=12264