Here is a thread from a while back. I made a roll around table out of scrap wood and put the stand on top of it while I was rebuilding the 288. Later the stand was made into a lower, rolling stand that fit under the work bench by bolting the 6x6 portion onto the mover's dolly. Just be sure to balance the load! You can buy longer dolly's that would probably work better with the automatic - it is a lot heavier than the 3 speed and OD.https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?topic_id=8941&forum=4&post_id=95758#forumpost95758
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=148543