JD
It is very kind of you to offer. I will accept asap!
The puller I made was a 5" bolt circle out of 1/4" plate. I welded a piece of 2 1/2" exhaust pipe to extend over the hub. I then made a 1/4" thick end to which I welded a 3/4" nut. I used a grade 8 bolt with an old universal joint spider cup for a bearing surface to push with. I greased the bolt.
I gave it all I could, but got no movement.
The 1/4" plates were bowing pretty badly.
See picture (if it works).
John from KC
Attach file:
(44.23 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=151640