OD Lockout cable removal?
Posted by Sloride75 On 2014/10/27 9:27:17
Howdy Gents. Decided I'd finally remove my OD lockout cable to see if I can repair it. However, I can't get the yoke end loose from the OD. The parts manual shows a simple clevis pin going through the yoke (3.299), with a cotter pin holding the clevis pin. I've gotten the cotter pin out and loosened up the clevis pin enough to spin around, but it won't pull out. Upon closer inspection it appears there might be a sleeve of some type inside inside the yoke, around the clevis pin - is this the case? Any ideas on how to loosen that up and remove the pin, or will I have to cut it out? Thanks!
On another note, I haven't posted lately but have been enjoying my car. Saturday night cruise in picture attached. It was snapped within a few minutes of arriving, and this was pretty much the standard sight for most of the time we were there. Amongst several dozen immaculately restored, detailed and resto-modded cars (including the Chevy with a 3x2 setup next to my car), my "old used car" sure does get a lot of looks. I love how many smiles and stories it evokes. "My neighbor/uncle/granddaddy/dad had one of these when I was a kid! I remember riding/falling asleep/having a blast in a car just like this!"
Attach file:
(115.58 KB)
On another note, I haven't posted lately but have been enjoying my car. Saturday night cruise in picture attached. It was snapped within a few minutes of arriving, and this was pretty much the standard sight for most of the time we were there. Amongst several dozen immaculately restored, detailed and resto-modded cars (including the Chevy with a 3x2 setup next to my car), my "old used car" sure does get a lot of looks. I love how many smiles and stories it evokes. "My neighbor/uncle/granddaddy/dad had one of these when I was a kid! I remember riding/falling asleep/having a blast in a car just like this!"
Attach file:
(115.58 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=152024