Re: 21 series mirror templates

Posted by JWL On 2014/11/13 17:33:31

Howard, I have seen mirrors like the one that was mine on other Custom Clippers, so I believe it to be correct. I took two #10 (I think that was the size) flat washers and ground off two flat sides on each so they would fit into the groove of the trim molding and be flush with the raised part. This made a more secure fitting as there was better mirror bracket contact with the molding. The mirror bracket fastened on with sheet metal screws, at least that is the way mine was mounted. It gave a good view to the rear and did not interfere with the vent window. I would think that one on the passenger side would be for appearance only and not give much of a view due to size and location.

(o{}o)