Re: Had this problem before, 49 Custom 8 won't go into gear

Posted by JWL On 2014/11/30 17:23:34

On both of the bearings the small ends of the taper go to the inside of the hub. Strongly suggest you consult a service manual so as to reassembly the parts. The wheel bearing adjustment is critical, as is the amount of grease in the bearings, as is the installation of the grease seal. All of these parts are too critical to safety to not be done properly. Is there someone you know who can help you with this job? If so, strongly suggest asking them for help. I could help if you were in Austin. Please proceed with caution.

(o{}o)