Re: Fabricating an engine stand

Posted by Packard Illiterati On 2014/11/29 12:31:21

Hi Owen,

The search I tired was using any combination of "engine", "stand", "rebuild", "support", and "motor". I do recall a post a little while back about someone making an engine support using wood. What I want to make is a rebuild stand that can rotate and similar to the OTC-1750 used for diesels. I just don't want to spend $3500+ when I can fabricate the same for under $1k.

Many of the older inline engines were supported on the side unlike many of today's lighter alloy engines, so it would get plenty of use. That's why I'm okay with fabricating one. This Packard is our first restoration, and we've already acquired 2 other project cars for restoration.

This engine stand would be used for rebuilding many other engines as well, as the business my brother and I are starting is a automotive restoration business. Even my father has joined us and will be restoring/rebuilding the entire electrical systems starting with the radio.

Warm regards!