Re: Stuck lower knuckle bushing.

Posted by HH56 On 2015/3/11 9:37:16
Nice looking engine. On the block below the head parting line check within the boxed area for a stamped number -- Usually was on a smoothed section but sometimes partially went into the rougher casting. It could be faint or partially covered by now if the block was prepped well for painting.

Attach file:


jpg  (140.44 KB)
209_550053102faae.jpg 1280X960 px

This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=158818