Re: coil and condenser question

Posted by PackardV8 On 2015/5/5 21:44:57
If eleminating the extra conendser at the coil does not help then the coil is suspicous.
HOWEVER, it could be the wiring to and from ign switch.
1. eleminate the extra condenser at the coil.
if that doesn't get engine running good then
2. Use a TEMPORARY jumper wire from the pos post of battery to positive side of coil (u did day the car is negative ground).
If that does not work then a baad coil. replace the coil.

DO NOT LEAVE THE JUMPER WIRE CONNECTED INDEFINTELY!!!
Connect the jumper ONLY for the time u are attempting to actualy start and run the car. Disconnect it when taking a smoke or cofffe break or any other kind of break.

This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=161371