Re: Transmission Aft Throw Lever Hitting Transmission Mount
Posted by HH56 On 2015/8/4 12:05:51
Good question. The photos of the assy show serrated shafts and the levers just clamped and held on via a bolt passing thru a groove around the shaft. The question arises because the SM says the levers can be installed in one of 4 positions and doesn't mention being able to be a single serration off so there may be some kind of wide serration or keyed arrangement.
With the trans in neutral as a starting point, you might try removing the bolt and sliding the lever off to see if it is possible to align it differently. When in neutral the levers and rods should place the idler levers on the assy mounted to the block directly on top of one another. If the trans lever is a tooth off the idler levers would not be able to line up in neutral.
Attach file:
(30.27 KB)
With the trans in neutral as a starting point, you might try removing the bolt and sliding the lever off to see if it is possible to align it differently. When in neutral the levers and rods should place the idler levers on the assy mounted to the block directly on top of one another. If the trans lever is a tooth off the idler levers would not be able to line up in neutral.
Attach file:
(30.27 KB)This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=164940