Re: Utramatic rebuild?

Posted by HH56 On 2015/8/8 16:53:07

Yes, using Kanters kit and other parts. Not terribly difficult but does require some attention to detail and some special tools to pull and replace some of the bushings. If a 55 or 6 you may have to use some ingenuity or make a tool or two to duplicate a factory tool used to hold or remove the springs in a couple of places. Biggest issue is to inspect and replace things that looks worn. The unit is dependent on bushings and shafts having the proper clearances so any wear on either and the pressures are impacted.