Re: Clutch and Brake Arm Alignment

Posted by Packard 1948 On 2015/8/23 23:20:10

Hmmm...good info.

I will inspect the shaft and inside bore of the pedals (again) to see if there is any wear. I will also try to see if I can find any bushings of the proper bore to shim the outside of the pedals to bring them inboard a bit.

I originally tried to file the outboard side of each hole however that would have required a bit of filing and the holes would have been too wide to be "normal".

THANKS AGAIN and I will report back.