Re: Electromatic Clutch Issues

Posted by Packard 1948 On 2015/9/3 18:04:05

Hi All,

I found the problem!!!

It appears that the new rubber diaphragm in the electromagnetic clutch actuator slipped out from in between the two metal discs.

Strange symptom because when the engine is idling and when the electromatic clutch switch was pushed in the engine would simply quit. Kind of seemed like an ignition shorting out issue because there was no sputtering...just engine stopping as if the ignition switch was turned off. No strange noises or hissing sound...just shut down.

To deduce whether the issue was electric or mechanical (vacuum) I revved the engine up to high idle and then when the clutch switch was pushed the engine would still run but at a much slower idle and sputtered a bit.

So as to ensure nobody else falls for the same trick I did, make sure that the fused on washer is placed on the OUTSIDE of the two discs (not sandwiched in between).

See attached PDF with pictures of what I am talking (typing) about.

THANKS again for all of your suggestions.

Attach file:

---

Size: 219.12 KB; Hits: 82