Re: 54 Packard 327. 2 barrel carb wgd-2102s. rebuild

Posted by JWL On 2015/11/1 11:34:10
If you decide to try and drill it, use left hand drill bits. The LH motion will tend to loosen the broken part. Still, as O_D, and others have said it is a tricky procedure to do without damaging the threads in the top. If the drilling is at right angles to the top, then a drill press would be a good choice. You can clamp the top, and have straight drilling with better control than a hand held drill. Good luck.

(o{}o)

This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=168502