Re: Rear wing window removal
Posted by HH56 On 2016/1/21 11:18:50
With the vent closed the tab fits in the little box like affair with the extended portion toward the front of the car. You can see the outline as to how it sits on the bottom of the little box thing in your top photo. When the vent is opened the tab swings in toward the center of car until the leading edge hits the rear of box and stops the glass.
The rear is the same except that instead of the sort of rectangle shape it is more a triangle shape. The pointed end is toward the front and hits the same spot on the box to stop the glass.
I did not take detail photos of that assy and am not 100% sure if the two tabs go together or are separated. Mine has a kind of raised portion on the shaft so both tabs didn't want to fit within the box. I used a tab on top which acts as the stop and another on the bottom to act as a friction washer for the spring. Looking at the outline on yours I think that may be correct because just the round top of spring would not have made the elongated pattern that is visible.
Attach file:
(20.26 KB)
The rear is the same except that instead of the sort of rectangle shape it is more a triangle shape. The pointed end is toward the front and hits the same spot on the box to stop the glass.
I did not take detail photos of that assy and am not 100% sure if the two tabs go together or are separated. Mine has a kind of raised portion on the shaft so both tabs didn't want to fit within the box. I used a tab on top which acts as the stop and another on the bottom to act as a friction washer for the spring. Looking at the outline on yours I think that may be correct because just the round top of spring would not have made the elongated pattern that is visible.
Attach file:
(20.26 KB)This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=170986