Re: replace vent wing glass 47 Custom Super Clipper

Posted by packard1949 on 2016/1/21 9:13:58
I replaced wing glass on a 49-broke the remaining glass out-if it can be removed in tact-then it can be used as a pattern. Otherwise need to make a pattern using cardboard or something similar. Glass shops normally can supply replacement glass. The last one I did required some fine tuning as something from the frame was preventing the glass from fitting right. Then use a glass cement-recommended by the glass shop to secure it in place. It is not difficult but as with any old car project patience is required.

This Post was from: