Re: 2126 interior coming together........finally

Posted by custo eight On 2016/3/5 18:43:41

Howard.
Those pictures are very interesting. When the interior was dismantled, I took most of the pieces to the upholstery shop but kept a few simple ones/complicated ones at home. These were mostly the ones that required the 1/4" trim molding, ie front kick panels, front seat side trim and back seat kick panel. When I uncovered the back seat kick panel their was obviously a round hole in the middle (covered previously) and two grill/speaker cutouts either side. The 1/4" trim strips continued across the grill cutouts so they were never meant to hold grills/speakers. It must have been an option. The question I have for future (still a ton of stuff {$$$$$} to pay for to finish) is: would this Dual Stream unit work under the back seat with heater hose plumbed in series. Seems like it would, just need the controls, plenums and grills along with the shortened stainless steel trim. My resto shop could likely cut the trim and hammer the ends to roll finish.....they are good......