Re: Hydraulic stop light switch

Posted by 55PackardGuy On 2019/6/23 14:22:58

I'm resurrecting this thread because it speaks to a problem that just popped up. My brake lights don't work. Tail lights and signals do. Some of the information on the thread so far is helpful, but it deals mostly with problems after the brake light switch.

This is a '54 Clipper Deluxe with Easamatic brakes.

(Brake/tail lights have always worked except when left bulb loosens up sometimes.)


Questions:

1. Location of brake light switch on Easamatic.

2. Location of wiring supplying power to the switch and
from the switch to the tail lamps.

3. Location or description of wires/ connections/relays under dash? (in addition to those offered already by HH).

4. Any wires running near the master cylinder or under the car?

5. Wire description for brake lights in trunk. (again, in addition to those above by HH)


-- Additional info on location and description of wires would be helpful.


I couldn't find this information in the Shop Manual.

Thanks for any help you fellows can give.

Guy

(If this info is discussed in another thread, I apologize. I found this thread through a search for brake light switch.)