Re: Headlamp circuit breaker mount

Posted by HH56 On 2016/5/11 14:18:28

I you are using the inline setup, once the old breaker is off, the brass tab will extend out with a hole in the end. Use the hole and a short screw and nut to attach one wire from the new breaker & holder to whichever side of tab provides the most room. Use another short screw and nut to attach the two or three wires that used to be on the broken side end of old breaker (B terminal of switch) to the other wire from new breaker. Insulate well and tuck wires up so they won't interfere with anything.

Attach file:

---

  (66.00 KB)