Re: '54 Convertible Windshield Washer
Posted by HH56 On 2016/7/11 12:46:53
The wiper switch provides a ground for the washer and I believe all 54s should have the electric style wiper switch. The electric washer was an option though so maybe not and your car might have the earlier type switch. You do need to verify there is a short pigtail wire attached to the switch that the washer can plug into. If a washer was never installed it is probably coiled up just inside the bottom of the shroud. In addition, there is a black button in the center of knob. On non washer equipped cars it probably will not move. The non moving black button changes out to one that you can push in which completes the ground circuit when pushed. If you have the mechanical switch used 53 and earlier then you will need to find the proper switch and knob or provide a pushbutton somewhere else to supply a ground for the washer.
The washer should have two wires connecting to the solenoid (black cap for 6v washers, red for 12v). They may be short pigtails and if so there is another 3-4 ft long 2 wire harness which brings those wires inside the car. If yours is missing you will have to make or find one. One wire goes to the aux breaker on back of cluster for the voltage and the other wire connects to the pigtail coming from switch for the ground.
Here are some instructions for installing the 54 washer which may help. Part of the instructions are cut off each sheet but there is overlap between the 3 so it appears complete.. Still, a bit hard to read but maybe the illustrations are enough. It appears the black wire went to the circuit breaker. Function wise, it doesn't really matter which wire goes where but if the wires already have a terminal on the end that might determine which wire went to a particular location.
Attach file:
(151.23 KB)
(144.87 KB)
(152.86 KB)
The washer should have two wires connecting to the solenoid (black cap for 6v washers, red for 12v). They may be short pigtails and if so there is another 3-4 ft long 2 wire harness which brings those wires inside the car. If yours is missing you will have to make or find one. One wire goes to the aux breaker on back of cluster for the voltage and the other wire connects to the pigtail coming from switch for the ground.
Here are some instructions for installing the 54 washer which may help. Part of the instructions are cut off each sheet but there is overlap between the 3 so it appears complete.. Still, a bit hard to read but maybe the illustrations are enough. It appears the black wire went to the circuit breaker. Function wise, it doesn't really matter which wire goes where but if the wires already have a terminal on the end that might determine which wire went to a particular location.
Attach file:
(151.23 KB)
(144.87 KB)
(152.86 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=178902