Re: Dual master cylinder for Series 23

Posted by acolds On 2016/12/11 14:33:18

not the same as yours but mine is under floor and oem master is mounted to frame . I made my first template from cardboard to make sure bracket would fit. Next test piece from thin steel from furnace duct scrap. Final piece is made of steel which mounts master cylinder onto bracket. Bracket bolts to frame in holes which mounted factory master cylinder. location of bracket was determined by the location of piston on new master (which I used from AMC car with drum brakes). The adjustable rod I used was made from a grage 8 bolt and clevis I got from McMaster Carr. The angle bracket on front of master cylinder was added because the hole in OEM linkage was present and I figured it would not hurt to have extra brace. There is a company that makes kit for my car but after looking at it and the price decided I would build my own. I did have to enlarge the hole in the floor to check fluid from above. Has been in use for about three years no trouble yet. Now I don't have to worry about failure from single master .

Attach file:

---

  (234.32 KB)


  (248.94 KB)


  (383.92 KB)


  (272.72 KB)