Re: My golden anniversary
Posted by HH56 On 2017/4/18 9:11:28
Here are a couple of photos provided by BDeB showing the location of the two screws Ross mentioned and the plate which holds the switches. The wire loom may have some clamps around it which will need to be removed before the switches will drop down very far.
Above all, if you are not going to replace the loom be extra gentle and careful not to bend the wires any more than absolutely necessary. The old rubber and fabric insulation is most likely so brittle and rotten that any sharp bends or undue movement can cause it to fall off in chunks.
Attach file:
(130.46 KB)
(169.61 KB)
Above all, if you are not going to replace the loom be extra gentle and careful not to bend the wires any more than absolutely necessary. The old rubber and fabric insulation is most likely so brittle and rotten that any sharp bends or undue movement can cause it to fall off in chunks.
Attach file:
(130.46 KB)
(169.61 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=190441