Re: Install backup light
Posted by HH56 On 2017/5/14 8:43:32
Thanks for posting the instructions. Correct me if I am wrong but those appear to be for the 48-50 models. I believe the 41-47 Clipper had just a single lamp with a support which mounted vertically on the gravel shield forward of the bumper rather than horizontally off the trunk panel. If I am incorrect and they did use the type which mounts to the trunk panel that would make finding Clipper reverse lights a lot easier as there seem to be more of those shown in the illustration hitting ebay.
The switch bracket looks like it would work and appears easier to make than the earlier type which has two sharp 90 degree bends, one of which is at an angle. Here is an incomplete illustration of the earlier bracket that is on my 47. Have never seen any documentation on the actual reverse light installation specific to the Clippers.
Attach file:
(101.27 KB)
The switch bracket looks like it would work and appears easier to make than the earlier type which has two sharp 90 degree bends, one of which is at an angle. Here is an incomplete illustration of the earlier bracket that is on my 47. Have never seen any documentation on the actual reverse light installation specific to the Clippers.
Attach file:
(101.27 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=191685