Re: OD kick down switch

Posted by HH56 On 2017/8/14 13:40:03
Should mount in the hole in the accelerator bracket positioned low on the engine side of firewall. Switch up-dn height is adjusted so the switch plunger is depressed and switch changes state when the accelerator nears full throttle. If you are using the NAPA or Cole-Hersee aftermarket replacement sw the two terminals close to the plunger are for the relay power ground coming from governor and lockout sw. The two far or upper terminals are the ign cutout circuit.

Attach file:


jpg  (55.51 KB)
209_5991edae77979.jpg 1126X990 px

This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=194954