Re: turn signal cancel switch

Posted by HH56 On 2017/12/17 20:56:31
That ring will need to slide up so you can move the column maybe 3/16. I had to do it on the 47. I can't remember on the 52 if there is a double clamp under the dash for the shroud and column or not. You might remove the bottom half and look up to see if there is another clamp holding just the column. I did have to pry the column as I didn't have any luck just trying to pull it. If you have a rubber collar at the floor plate that could also be sticking to the column and holding things up.

This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=198529