Re: Aluminum Head?

Posted by HH56 on 2021/1/29 14:49:45

PackardDon wrote:
Last I checked, Kanter had aluminum heads for for a very high price. That said, any of the cast iron heads of the era will fit but I recall seeing in the Service Counselor something about which one was recommended as a field replacement but I cannot locate it now.

I don't remember a service article on a suggested replacement but a few years ago Ross did post a reply to another posters question on the same subject. He did have a couple of recommendations as well as one or two definite NO's. On the do not use heads the pinging caused by the increased compression ratio that resulted could not be compensated for via timing, fuel or any other work. If anyone remembers or can find that post it might be beneficial.

This Post was from: