Re: Oil Bath Air Cleaner Support Bracket

Posted by HH56 On 2018/5/19 12:41:22

I believe the bracket Don shows is the same as your car would have. Without some dimensions you will need to set your cleaner in place and take measurements. IIRC the bracket is approx 1/8 thick material and a little over 1" wide.

Main difference between brackets is the length from the bend for the block mounting bolt to the slot and the degree for the two angles at the block side. The angles controls the 90 degree across the block and horizontal height portion and the length is for the different carbs. Kev has a couple of photos of his engine. I believe his bracket is different but you can still get an idea of how it mounts to keep the cleaner horizontal and at 90 degrees to the carb.https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=13219#forumpost13219