Re: 327ci mystery

Posted by Packard Don On 2019/6/15 21:36:00

The exhaust and intake manifolds are bolted together from the bottom under the carburetor where the choke's heat exchanger is. There is, I believe, also a gasket between the two halves but no need to get one if you're not taking them apart.

In addition to the three-piece gasket set, you'll need the doughnut gasket at the exhaust connection. No, no sealer in any of these areas. As for tightening sequence, you would have to refer to the service manual but a typical rule of thumb is to tighten center out.