Re: 1948 Packard not starting

Posted by Joe Santana On 2020/3/18 6:11:19

Assuming oil and filter cleaned and changed and gas is clean, I'd tackle the timing and be sure it is set correctly.

Know the position of your #1 cylinder and set up the distributor accordingly. When you crank it with the starter, note if the fan turns clockwise or counter clockwise and be sure the spark plug wires are in the correct distributor position following the firing order in CW or CCW.

If you removed the oil pump, be sure it was replaced in the correct orientation. It interfaces with the distributor. It can be 180 degrees off and make it very difficult to start.

If you have fuel and spark, have faith, it will start.