2126 model wiring question/diagram

Posted by custo eight On 2020/4/2 16:05:40

Again....working on loose ends (literally) wiring etc and have an issue with electrical connections under the bonnet. Had a new Narraganset wiring harness installed and gradually wired to circuits as the car progressed. Generally, with exception of radio and heater connections, other minor interior lighting, door switches, head light switches etc were completed and tested with no issues. Rebuilt engine had been started several times but not thru the final ignition switch wiring. Before taking it from resto shop, I had them do the final wiring to ignition.
At test, battery had been connected but needed a charge to test the starting circuits. After charging for 30 minutes, bumped the starter and the engine turned over as normal...no gas but did have starter engaged.
Once back in my garage (roll back delivery), I hooked up a trickle charger after disconnecting the hot lead. After charging overnight, disconnected the charger. When I went to put the hot lead on the post, got a significant spark (10-15amps approx) and the overdrive relay, one closest to drivers side, clicked shut.
There are several wires that have not been connected including Horn relay pair, electric overdrive lock out pair (optional with harness), "?accelerator switch?" pair and direct speed switch wire.
Accel switch pair?? is big question since the accelerator switch is already wired with a pair of a different color and correct end fitting hardware instead of the "pins".
Any insights would be appreciated.

Attach file:

---

  (180.30 KB)


  (217.10 KB)


  (189.14 KB)


  (187.32 KB)


  (207.36 KB)


  (209.37 KB)