Re: 2126 model wiring question/diagram

Posted by custo eight On 2020/4/9 12:26:00

Howard,
I'm pretty sure you are correct on the mis-labeling issue. At the tail end of the wiring harness as it connects to starter solenoid, the two R-G pair might be unnecessary at which point I will heat shrink the connections to avoid any possible contact. Out of one of the loom end runs, one R-G pair, and a single green wire with eye end, runs out in engine compartment. Pretty sure that is the correct area for that portion of loom run since the wires connected to starter solenoid are exiting just prior to the R-G pair and Green single wire. There isn't much excess wire in at the starter solenoid connection.
The green single wire is labeled "direct speed switch" and one of your diagram/drawings shows the "direct speed"switch possibly associated with the electromagnetic clutch (which I think we determined the car isn't equipped with). Just trying to clarify where that single green might connect if it connects at all. It is long enough to reach the forward end of engine. Not sure if it would reach to switch for overdrive at transmission location. Scratchin' head again but meanwhile busy sorting out wiring fiasco from resto shop. Won't even go into details but the wiring at OD solenoid was completely reversed. Hoping I haven't lost a coil or other damaged circuit.
Cheers
Bob