Re: 2126 model wiring question/diagram

Posted by HH56 On 2020/4/9 13:34:06

The single green with ring terminal should go to the direct speed switch and can be covered as can each individual wire in the other two pairs that have bullet type terminals. Heat shrink would be best. One of the pairs should go to the solenoid on the control valve and the other pair would go to the accelerator switch. If present, that switch would be mounted on the firewall below the coil and near the inner side of OD relay. There should also be an extra wire at the governor which can be hooked up to the EC pigtail but will be unused. It's other end will be one of the covered pair going to the accelerator switch.

Here is a layout of where the components would have been if you want to neatly dress the wire bundles accordingly.

Attach file:

---

  (61.51 KB)