Clutch upgrade

Posted by Ed B On 2020/4/22 15:12:03

I am in the process of resurrecting a 1950 288 w/OD. Prior to installation, Id like to replace the clutch/pressure plate and due to clearance (non-stock), I'd like to upgrade to a hydraulic throw-out bearing.

It has a 10" clutch and the pressure plate has the '3 fingers' for the throw-out bearing to ride on.

I understand there are pressure plates that have a diaphragm movement rather than the 3-finger movement. Apparently, to make this work, I need the diaphragm variety.

Does anyone have any numbers and sources.

Thanks for any ideas. I'm not trying to make a hot rod, just a distinctive ride. Where better to start than Packard.

Ed...