Re: underseat heater 47 super clipper

Posted by HH56 On 2020/5/21 10:16:58

Yes. It will probably be fairly tight. Something I have found on various motors is often the end of the screw seriously bites into the shaft. Rust on the shaft and the damage from the screw can make pulling the blade and hub off a bit difficult. If yours is bad you may need to use a fan hub puller to slide the hub over the damaged area. The commercial pullers I see on amazon are way too big so you may need to come up with something using the same principle but smaller. Be careful not to force something in that would bend the blades or there could be a balance and vibration problem when you put things back together.