brake light switch 47 clipper
Posted by Josef Lichtenberg On 2020/6/3 12:49:54
Dear all,
i have a new brake light switch from kanter and it is sweating brake fluid a little bit at the thread. the old switch was assembled without any seal inside the hollow screw number 1.0100 . there was no leak.
my question: must there be normaly a cupper ring or something else? in the "master parts book" is no picture.
I have tighten the switch firmly. i am afraid to destroy the switch if i tight it more tight or to have a leaking break. do you have got any thoughts?
best regards Josef
Attach file:
(117.83 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=223040