Re: Timing Chain wear allowance

Posted by Tim Stockwell On 2020/6/29 20:43:17

Thanks Dave,

I will double check the firing order and make sure fuel is being delivered. I did at one point have all the wires connected to the plugs as they were sitting on top of the cylinder head and they were all snapping very well. It is hard to believe the firing order would change since all the wires in their harness have a specific length and location. Here in Oregon we can buy non-ethanol gas that is what I only use. I also will will fill the carb from the top by removing the 2 screw cover plate over the metering rods.
I am considering also having the wife crank the engine to see of there is sufficient vacuum pull at the carb.
I will let you know tomorrow of what I find.

Tim