Re: 47 Custom Super Clipper Coil
Posted by HH56 On 2020/7/5 11:40:57
Interesting. I would like to know too and hope someone is familiar with the construction. Will say that if that piece is part of and required to connect to the coil then the replacement coil is not the same as the stock Packard item.
On the stock coils, for the coil wire to distributor Packard used the same type terminals on both ends as is used for the distributor cap end on the plug wires. The terminal and wire was pushed straight into the coil opening and just like modern coils, a rubber boot covered the end of the coil and opening.
Attach file:
(51.08 KB)
(53.36 KB)
On the stock coils, for the coil wire to distributor Packard used the same type terminals on both ends as is used for the distributor cap end on the plug wires. The terminal and wire was pushed straight into the coil opening and just like modern coils, a rubber boot covered the end of the coil and opening.
Attach file:
(51.08 KB)
(53.36 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=224283