Re: Tappet Clearance Tool J-4540? Valve Guide Driver J-2577?
Posted by JeromeSolberg On 2021/3/15 20:25:46
John,
Re: Reaming the Guides for Clearance:
Good point! I was going by the statement that "in the last few years using Egge or Kanter guides reaming has not been necessary", but it seems like best practice. I found the following video which seems like a good tutorial:
Willys F-head valve guide install/reaming starting around the 7:30 mark
The manual says use a standard 11/32" reamer. Is this one appropriate?
0.3435" (11/32") Cast Iron Valve Guide Finish Reamer Anything else I should be aware of?
Thanks in advance
Jerome
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=231335